Product Image
Item Name
Price
If your Upper Ball Joint is fine but the rubber boot has perished, fit a new rubber boot and save around $20 per side. Suits all models except RV1.
$5.75 Add:
$68.00 Add:
2-1/8", brass. Suits 225
$5.00 Add:
To suit RV1 - VC 225 and 273
$42.00 Add:
The grey disc that goes behind the handle/winder to protect the door trim
$1.00 Add:
5-3/4" (146mm) diameter to suit: RV1 SV1 VF VIP VG VIP Chrysler by Chrysler CL CM High Beam Single Filament Single Beam
$22.00 Add:
5-3/4" (146mm) diameter to suit: RV1 SV1 VF VIP VG VIP Chrysler by Chrysler CL CM High/Low Sealed Beam
$22.00 Add:
Fuel Tank Sender Unit to suit RV1 and SV1 models. Complete unit including new Seal and Locking Ring
$145.00 Add:
New reproduction, perfect copy of the original. Includes shaft.
$90.00 Add:
New reproduction, perfect copy of the original
$58.00 Add:
$123,456.00 Add:
$123,456.00 Add:
Salvaged. Crusty and dusty but not rusted out. Get out the wire brush!
$35.00 Add:
Salvaged. Crusty and dusty but not rusted out. Get out the wire brush!
$35.00 Add:
Salvaged. Crusty and dusty but not rusted out. Get out the wire brush!
$35.00 Add:
Salvaged. Crusty and dusty but not rusted out. Get out the wire brush!
$35.00 Add:
Salvaged. Crusty and dusty but not rusted out. Get out the wire brush!
$35.00 Add:
Made from aftermarket new old stock mechanisms and perfect reproductions of the original knob, these cigarette lighters have never been reproduced...
$38.00 Add:
To suit RV1 and SV1. Horizontal ridge design. Missing one tab and needs refinishing but otherwise a good example of a hard to find part.
$55.00 Add:
To suit RV1 and SV1. Horizontal ridge design. Missing tabs so will need to be fitted with double-sided tape. Needs refinishing but otherwise a good...
$50.00 Add:
Salvaged Window Regulator to suit RV1/SV1 Driver's Side Rear Door. Has been ultrasonically cleaned, regreased and tested. Includes linkage arm and...
$60.00 Add:
Suits all RV1-VK front drum braked models. This is just the "Cup" component.
$10.00 Add:
This is a set of 4 Brake Shoes to do both front brakes
$45.00 Add:
To suit all 9" drum brakes. Kit includes springs and clips to suit one pair of drum brakes
$36.00 Add:
Kit is for one wheel and includes: Inner Bearing, Outer Bearing, Seals Suits all RV1-VK front drum braked models
$29.00 Add:
$22.00 Add:
Unbent, undamaged. Picture used is for demonstration purposes only; your item will be the same type and in good useable condition but may look...
$35.00 Add:
$12.00 Add:
Hi Beam Dipper Switch to suit RV1 - VJ.
$16.50 Add:
Two pin type to suit all models with Points; RV1 - VH
$8.80 Add:
Sold as a pair, Single Piece Type
$25.00 Add:
$16.00 Add:
$16.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Now selling for $14 cheaper than it was 10 years ago!
$38.00 Add:
Top quality hoses, made in Australia and individually tested to 3000psi. Includes both front hoses and the rear hose. Hoses are made to your order:...
$165.00 Add:
Includes keys x2, door barrels x2, barrel clips x2, and barrel seals. Note these are a direct replacement for Late VC - VG. They can be used in...
$55.00 Add:
$99.00 Add:
Re-key your doors and ignition to use the same key. Ignition Barrel is exact replacement for all models from RV1-VG. Door Barrels are exact...
$80.00 Add:
Suits all models from RV1 - VG
$22.00 Add:
$46.00 Add:
To suit RV1 - VG Quality digital print
$19.00 Add:
$99.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Now selling for $14 cheaper than it was 10 years ago!
$38.00 Add:
One kit does both vent windows
$7.50 Add:
Not identical but very similar in style to the original Voltage Regulator
$55.00 Add:
$42.00 Add:
$42.00 Add:
$18.00 Add:
Original Style
$6.00 Add:
To suit RV1 - VF Quality digital print
$26.00 Add:
Full gasket set to suit 225
$131.00 Add:
$11.95 Add:
Copper-faced gasket, old stock, brand unknown
$11.00 Add:
To suit 225. Also known as Timing Cover to Harmonic Balancer Seal
$12.00 Add:
Suits RV1 - VF Slant. Image is example only, actual unit has both fittings pointing in the same direction as per original. Sealed unit.
$55.00 Add:
To suit 225
$50.00 Add:
To suit 225
$14.00 Add:
To suit 225
$18.00 Add:
To suit 225
$18.00 Add:
To suit 225. Square-edged seal
$4.00 Add:
To suit 225
$3.30 Add:
$5.85 Add:
$33.00 Add:
To suit all 225. Fel-Pro brand, made in USA.
$21.00 Add:
Spark Plug Tube from a salvaged engine
$4.00 Add:
To suit 225
$40.00 Add:
$4.40 Add:
Includes all parts pictured (not sure if there should be more). Suits Slant and 273 up to VF EDIT: No longer includes springs
$16.00 Add:
$27.50 Add:
$74.50 Add:
Includes: Mopar orange ignition box remanufactured distributor Ballast resistor Wiring Loom conversion Electronic Coil Instructions
$390.00 Add:
Includes: Mopar orange ignition box remanufactured distributor Ballast resistor Wiring Loom conversion Instructions Your original coil will be reused
$340.00 Add:
Front Axle Hub Seal. You do not need to buy this product if you are buying the Front Wheel Bearing Kit as it is included in the kit.
$7.70 Add:
$12.00 Add:
$12.00 Add:
Suits RV1 - VF Slant with original Goss Fuel Pump. Quality Australian product. Will not fit the following: Modern sealed Fuel Pump Slant with Carter...
$80.00 Add:
$55.00 Add:
Kit to suit the rebuild of Australian Slant 6 Oil Pumps
$280.00 Add:
$110.00... more info
$340.00 Add:
$340.00 Add:
$340.00 Add:
$340.00 Add:
$340.00 Add:
Original Rope Type
$35.00 Add:
$320.00 Add:
$320.00 Add:
$320.00 Add:
$88.00 Add:
Adjustable, Tru-Roller type.
$148.50 Add:
$135.00 Add:
$11.00 Add:
$120.00 Add:
$174.00 Add:
Wow, this thing has everything; it's fast AND expensive
$385.00 Add:
$11.00 Add:
Sold as a set
$165.00 Add:
Sold individually
$5.50 Add:
$66.00 Add:
$5.00 Add: