Product Image
Item Name
Price
Rough, apart from top panel. Faded too. Could be cleaned up for bash car. How desperate are you?
$25.00 Add:
Minor damage to top and bottom panels. A bit faded. Backing board needs replacement.
$40.00 Add:
Covered in primer overspray that can be cleaned off. Some damage to middle panel. Backing Board needs replacement.
$27.00 Add:
Covered in overspray and pretty rough. Would look better cleaned up and on a new board. Would also look better on fire. Damage to trailing edge of...
$25.00 Add:
$1.00 Add:
The grey disc that goes behind the handle/winder to protect the door trim
$1.00 Add:
Nobody likes to have their nuts seized. Here is the solution to the bang noise you just heard when you tried to tighten your panel nuts up
$1.75 Add:
To suit RV1 - VG Quality digital print
$19.00 Add:
These are the brackets used to mount the Front Sway Bar to the K-Frame
$25.00 Add:
These are the bushes to suit the aftermarket brackets used to mount an 18mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 20mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 22mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 23mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 23mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 25mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 27mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 30mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
Quality kit with braided sheathing
$110.00 Add:
Quality kit with braided sheathing
$110.00 Add:
An affordable alternative to buying new lower ball joints if the only problem with your existing ones is perishing rubber. Suits all models,...
$7.70 Add:
3 available, all in poor condition as pictured. We can also arrange to have these restored for you; POA because we have no idea how much it will cost...
$40.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
To suit RV1/SV1 Quality digital print
$17.00 Add:
$55.00 Add:
To suit 225
$18.00 Add:
Suits all Slant and Hemi engines
$4.50 Add:
These original salvaged conical washers are to suit Slant and V8 engines.
$5.00 Add:
Unavailable as a factory-correct reproduction, these original salvaged washers feature the concave shape. Suitable for both Slant and Hemi
$5.00 Add:
Early model Master Cylinder. This is the type with the cover held down with the bolt, but it can be used to replace the type with the screw type lid,...
$220.00 Add:
This kit is to suit the rebuild of the RV1-SV1 Master Cylinder
$45.00 Add:
$25.00 Add:
$220.00 Add:
I bought this with a 1950's car radio and wondered what it was. A completely sealed cylinder with something moving (not rattling, but moving like it...
$16.00 Add:
This will fit all Torqueflite transmissions from VF to CM. It can be used to replace the earlier one pin type, which is no longer available, with...
$55.00 Add:
Standard bulb as used in all number plate light assemblies
$1.00 Add:
The ring and bracket that attaches the Oil Filter Canister to the engine block. This one has been chrome plated in the past but requires stripping...
$35.00 Add:
Canister type oil filter to suit RV1/SV1 Slant and AP6/VC V8
$25.00 Add:
Suits all models
$16.50 Add:
To suit 225. Square-edged seal
$4.00 Add:
Kit to suit the rebuild of Australian Slant 6 Oil Pumps
$280.00 Add:
To suit 225
$3.30 Add:
$110.00... more info
$340.00 Add:
$340.00 Add:
$340.00 Add:
$340.00 Add:
$340.00 Add:
$123,456.00 Add:
Suits TorqueFlite 904
$18.50 Add:
Made from aftermarket new old stock mechanisms and perfect reproductions of the original knob, these cigarette lighters have never been reproduced...
$38.00 Add:
$5.85 Add:
$11.00 Add:
$28.90 Add:
$20.00 Add:
$21.80 Add:
To suit RV1 and SV1. Horizontal ridge design. Missing one tab and needs refinishing but otherwise a good example of a hard to find part.
$55.00 Add:
To suit RV1 and SV1. Horizontal ridge design. Missing tabs so will need to be fitted with double-sided tape. Needs refinishing but otherwise a good...
$50.00 Add:
Standard Bulb used to light the Radio Dial and several other interior applications
$1.00 Add:
Sold as a pair, Single Piece Type
$25.00 Add:
$22.00 Add:
$99.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Now selling for $14 cheaper than it was 10 years ago!
$38.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Hoses are made to your order: please e-mail us after placing an order if you...
$55.00 Add:
This is an original piece of glass for a rear door. The same piece of glass was used for both sides; the Armourplate logo is reversed when viewed...
$50.00 Add:
Suits TorqueFlite 904, Borg Warner 3 Speed Manual, Borg Warner 35 Automatic
$32.00 Add:
$7.50 Add:
$25.00 Add:
$25.00 Add:
Original Rope Type
$35.00 Add:
$60.00 Add:
$60.00 Add:
$68.00 Add:
Quality SuperPro polyurethane product. 4 bushes are supplied; enough to do 1 car
$45.00 Add:
Set includes enough to do one rear shock; 4x Washers and 2x Nuts
$19.00 Add:
Quality US-made product. Sold as a pair.
$155.00 Add:
Suits all models with 34mm dia front leaf spring bushes. Price is for 4 Bushes, enough for 1 car
$24.00 Add:
Suits all models with 34mm dia front leaf spring bushes. Price is for a pair; enough to do 1 car
$38.00 Add:
Quality product. Sold as a set of 4. RV1 - VH models require 2 sets per car as they are used for upper and lower shackle bushes. VK - CM models only...
$20.00 Add:
Quality product. Sold as a set of 4. RV1 - VH models require 2 sets per car as they are used for upper and lower shackle bushes. VK - CM models only...
$45.00 Add:
Includes Bearing, Lock Collar and Rear Axle Seal. One set per wheel.
$86.00 Add:
$22.00 Add:
$18.00 Add:
$150.00 Add:
$33.00 Add:
To suit RV1 and SV1 Slant 6 as well as AP6 - VE 273
$16.20 Add:
$99.00 Add:
To suit all TorqueFlite transmissions built after 1966
$5.50 Add:
To suit all TorqueFlite transmissions built prior to 1966
$9.00 Add:
$320.00 Add:
$320.00 Add:
$320.00 Add:
$88.00 Add:
Adjustable, Tru-Roller type.
$148.50 Add:
$135.00 Add:
For the passenger's side; on your right when you open the bonnet!
$68.00 Add:
For the driver's side; on your left when you open the bonnet!
$68.00 Add: