Product Image
Item Name
Price
$18.00 Add:
55.6mm Fits all models
$10.00 Add:
$50.00 Add:
Front Axle Hub Seal. You do not need to buy this product if you are buying the Front Wheel Bearing Kit as it is included in the kit.
$7.70 Add:
$99.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Now selling for $14 cheaper than it was 10 years ago!
$38.00 Add:
Salvaged Front Door Window Glass, good condition with no scratches or chips.
$45.00 Add:
This door is straight but has rust along the lower edge of the door as pictured. This could be repaired with one of our panels but unfortunately, the...
$100.00 Add:
This door is straight but unfortunately has extensive rust on the inside. This is strange because the rust has only just started on the outside...
$90.00 Add:
This door appears to be rust free and straight aside from a slight bend to the leading edge, from it being opened too far perhaps. Easily fixed, and...
$180.00 Add:
$5.00 Add:
$59.00 Add:
$59.00 Add:
Fits VE - VG; may also fit other models with some trimming. Includes cutout to fit 6" speakers. A professional-looking way to add speakers without...
$220.00 Add:
Fits VE - VG; may also fit other models with some trimming. Includes Custom Autosound 80W speakers. A professional-looking way to add speakers...
$248.00 Add:
$35.00 Add:
$125.00 Add:
$125.00 Add:
$16.00 Add:
$16.00 Add:
Lower Shock Absorber Bush as fitted to base of front shock absorber. An affordable alternative to replacing one of your front shocks if the only...
$13.80 Add:
Genuine Mackay, Australian made. Includes inner tubes.
$80.00 Add:
Salvaged Front Vent Window, good condition with no scratches or chips.
$40.00 Add:
Salvaged Front Vent Window, good condition with no scratches or chips.
$40.00 Add:
Kit is for one wheel and includes: Inner Bearing, Outer Bearing, Seals Suits all RV1-VK front drum braked models
$29.00 Add:
$12.00 Add:
$12.00 Add:
$55.00 Add:
$18.00 Add:
$159.00 Add:
Salvaged Front Windscreen to suit AP5 - VC. Good condition with no scratches or chips. There is no way I'll be posting this but it can be couriered...
$100.00 Add:
$4.00 Add:
This is the seal around the Filler Tube that screws to the Boot Floor. Steel insert as per factory.
$76.00 Add:
To suit AP5 - VH Quality Digital Print
$6.50 Add:
Suits all models
$2.20 Add:
Suits RV1 - VF Slant with original Goss Fuel Pump. Quality Australian product. Will not fit the following: Modern sealed Fuel Pump Slant with Carter...
$80.00 Add:
Suits RV1 - VF Slant. Image is example only, actual unit has both fittings pointing in the same direction as per original. Sealed unit.
$55.00 Add:
If you have traced the problem with your Fuel Sender to a float which is filling up with fuel due to a leak, here is your solution. This type is as...
$16.00 Add:
If you have traced the problem with your Fuel Sender to a float which is filling up with fuel due to a leak, here is your solution. This type is made...
$16.00 Add:
Suits all models. If you are missing a Ground Strap and enough money to buy a new one, buy this crusty old one instead and clean it up
$2.00 Add:
Suits all models. If your Fuel Gauge is stuck on empty, the problem could be a poor ground through the Ground Strap.
$15.00 Add:
Suits all models. If your Fuel Gauge is stuck on empty, the problem could be a poor ground through the Ground Strap. This is the stainless steel...
$22.00 Add:
This is the seal between the Filler Tube and Tank. Suits AP5 - CM
$20.00 Add:
To suit only models with fuel sender pickups that have been enlarged to 3/8"
$25.00 Add:
To suit all models with standard 5/16" sender tube
$37.50 Add:
$52.00 Add:
Suits all models
$9.00 Add:
Correct part for models with J-Bolt. Models which do not use this type of J-bolt may still use this if: the hole in the chassis rail in which the...
$22.00 Add:
To suit AP5 - AP6 Regal
$123,456.00 Add:
To suit Wagon
$123,456.00 Add:
$910.00 Add:
$123,456.00 Add:
To suit Wagon
$123,456.00 Add:
Good condition
$5.00 Add:
$5.00 Add:
$40.00 Add:
A nice grille with perfect straight bars and almost no damage. The only dents I could find were one between the A and the L and one just after the I....
$210.00 Add:
$0.50 Add:
$12.00 Add:
Has spent decades under a car and looks like it. Works fine; save money by buying rusty!
$5.00 Add:
Quality Australian-made product.
$95.00 Add:
Quality Australian-made product.
$39.00 Add:
Two required per car. Quality Australian-made product.
$84.00 Add:
$54.00 Add:
Headlight Switch Harness, viciously hacked out of cars wrecked back in the day when it wasn't worthwhile to carefully remove the whole wiring loom;...
$20.00 Add:
7" (178mm) diameter to suit: AP5 AP6 VC VE VF VH VJ High/Low Sealed Beam
$20.00 Add:
To suit all AP5 - VC. Drill the holes out for your heater or install as-is if you don't have a heater
$20.00 Add:
Hi Beam Dipper Switch to suit RV1 - VJ.
$16.50 Add:
Exact reproduction of factory fitted item for AP5 - VK, suitable for all models from RV1 - CM
$28.00 Add:
Horn Switch Retainer Bush Set. There are the 3 little bushes that secure the horn switch. Set of 3
$6.60 Add:
This is to suit the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models...
$10.00 Add:
This is the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models which...
$44.00 Add:
Re-key your doors and ignition to use the same key. Ignition Barrel is exact replacement for all models from RV1-VG. Door Barrels are exact...
$80.00 Add:
Suits all models from RV1 - VG
$22.00 Add:
For use with Ballast Resistor
$58.00 Add:
For use with Ballast Resistor only. Made in Japan
$39.00 Add:
$46.00 Add:
If your indicator refuses to cancel after turning a corner, chances are one of the tabs has broken off. A common problem which is easily fixed with a...
$25.00 Add:
If your indicators are staying on constantly, here is your solution. Two-pin Flasher Can to suit all models.
$14.00 Add:
If your indicators are staying on constantly, here is your solution. Two-pin Flasher Can to suit all models.
$20.00 Add:
If your indicators are staying on constantly, here is your solution. Two-pin Flasher Can to suit all models. This is the larger, more elaborate type...
$20.00 Add:
Salvaged condition; all have minor surface rust on stalk but knob is not cracked
$20.00 Add:
A hard-to-find part. If you turn your original steering wheel upside-down you will notice a steel ring encircling the steering shaft spline socket....
$7.00 Add:
Before ordering this product, please note: you may only need the Cancelling Cam, which is much cheaper! If you are having an issue such as the...
$110.00 Add:
Standard bulb as used in all dashboard bayonet applications. Note VF - CM dashboards also include wedge type bulbs
$1.00 Add:
Round Wiring Harness Connector to join Instrument Panel PCB. Has part number 2791083, which suits the following models: VC Sedan & Utility Up to:...
$18.00 Add:
$22.00 Add:
New, wrapped in tissue paper to prevent scratching
$44.00 Add:
$10.50 Add:
Grubby but will clean up ok. Small hole above armrest, hard to see when installed. Backing board ok.
$55.00 Add:
Nice condition. Some minor overspray that can be cleaned off. Backing board is ok as well.
$60.00 Add:
Damage to trailing edge of lower 2 panels. Some overspray that could be cleaned off.
$27.00 Add:
Grubby but will clean up ok. Stainless strip good but carpet faded. Small hole above armrest that will be obscured by armrest when installed. Good...
$65.00 Add:
Perfect condition. Even the backing board is good enough to re-use.
$65.00 Add:
Grubby but could be cleaned up. No nicks or damage to vinyl. Carpet in crap condition, could be dyed or replaced. Stainless trim is good.
$50.00 Add:
Good Condition, minor hole over armrest which will be mainly hidden by the armrest pad. Some overspray which can be cleaned off.
$40.00 Add:
$1.00 Add:
Nobody likes to have their nuts seized. Here is the solution to the bang noise you just heard when you tried to tighten your panel nuts up
$1.75 Add:
To suit RV1 - VG Quality digital print
$19.00 Add:
These are the brackets used to mount the Front Sway Bar to the K-Frame
$25.00 Add: