Product Image
Item Name
Price
6 per car. Suits all models.
$4.50 Add:
Suits TorqueFlite 904, Borg Warner 3 Speed Manual, Borg Warner 35 Automatic
$32.00 Add:
Suits TorqueFlite 904
$18.50 Add:
Salvaged Crossmember to suit R and S Series Valiant
$90.00 Add:
To suit all models, auto or manual; note that this product is imported from the US so only features one thread, not two. Australian mounts were...
$49.00 Add:
Suits RV1 - AP6 These are the bolts that hold the Parking Lock Cover on. There are 5x per car. [note to self; these also fit...
$3.00 Add:
2 per car required for RV1-SV1, 3 required for VC-VG Also fits VH - CM
$7.00 Add:
To suit RV1 - early AP5 Manual Gearboxes
$42.00 Add:
To suit RV1 - AP5 Manual Gearboxes
$20.00 Add:
NOS Speedometer Cable Shaft; use this with your original cable sheath. This is to suit R and S Series Valiant only, both Auto and Manual.
$55.00 Add:
Not currently available (I'm working on it)
$38.50 Add:
Suits all RV1-VK front drum braked models. This is just the "Cup" component.
$10.00 Add:
Kit is for one wheel and includes: Inner Bearing, Outer Bearing, Seals Suits all RV1-VK front drum braked models
$29.00 Add:
Front Axle Hub Seal. You do not need to buy this product if you are buying the Front Wheel Bearing Kit as it is included in the kit.
$7.70 Add:
$12.00 Add:
$12.00 Add:
$12.00 Add:
Genuine Mackay, Australian made. Includes inner tubes.
$80.00 Add:
Lower Shock Absorber Bush as fitted to base of front shock absorber. An affordable alternative to replacing one of your front shocks if the only...
$13.80 Add:
Includes nuts and washers.
$30.00 Add:
Quality Australian-made Mackay Rubber product. 4 required per car
$15.00 Add:
Nolathane or Moog brand
$17.00 Add:
Used to adjust camber and caster. One set is enough to do both sides of 1 Upper Control Arm.
$40.00 Add:
Suits all models, excluding those fitted with solid disc brakes
$43.00 Add:
Suits all models, excluding those fitted with solid disc brakes. Wasp brand
$49.00 Add:
An affordable alternative to buying new lower ball joints if the only problem with your existing ones is perishing rubber. Suits all models,...
$7.70 Add:
$123,456.00 Add:
If your Upper Ball Joint is fine but the rubber boot has perished, fit a new rubber boot and save around $20 per side. Suits all models except RV1.
$5.75 Add:
If your Tie Rod Ends are fine but the boot is perished, here is your affordable answer
$5.85 Add:
This is the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models which...
$44.00 Add:
This is to suit the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models...
$10.00 Add:
This is to suit the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models...
$24.50 Add:
Sold as a pair, Single Piece Type
$25.00 Add:
$123,456.00 Add:
Suits all models
$49.00 Add:
These are the brackets used to mount the Front Sway Bar to the K-Frame
$25.00 Add:
These are the bushes to suit the aftermarket brackets used to mount an 18mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 20mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 22mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 23mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 23mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 25mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 27mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 30mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
Suits manual Steering Box
$35.00 Add:
Suits manual Steering Box
$15.00 Add:
Steering Shaft to Steering Box Coupling Repair Kit. Take the play out of your steering and make your steering more responsive. Fits all models.
$32.00 Add:
Pair of MDI Seals. Suits all models
$26.00 Add:
Torsion Bar to suit any 6 cylinder model (V8 Torsion Bars are slightly thicker)
$50.00 Add:
$25.00 Add:
This kit is to suit the rebuild of the RV1-SV1 Master Cylinder
$45.00 Add:
Early model Master Cylinder. This is the type with the cover held down with the bolt, but it can be used to replace the type with the screw type lid,...
$220.00 Add:
$220.00 Add:
This is a set of 4 Brake Shoes to do both front brakes
$45.00 Add:
$99.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Now selling for $14 cheaper than it was 10 years ago!
$38.00 Add:
Top quality hoses, made in Australia and individually tested to 3000psi. Includes both front hoses and the rear hose. Hoses are made to your order:...
$165.00 Add:
This is a set of 4 Brake Shoes to do both rear brakes. Does not fit Late CL 10" drums
$50.00 Add:
$99.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Now selling for $14 cheaper than it was 10 years ago!
$38.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Hoses are made to your order: please e-mail us after placing an order if you...
$55.00 Add:
$42.00 Add:
$42.00 Add:
$22.00 Add:
Gasket that goes under the Wheel Cylinder. Suits all models
$4.00 Add:
To suit all 9" drum brakes. Kit includes springs and clips to suit one pair of drum brakes
$36.00 Add:
Quality Australian-made product
$108.50 Add:
To suit RV1 and early SV1; one required per car. Quality Australian-made product. Suits all RV1 and SV1 body numbers up to SV1-2-542 and SV1-4-441
$170.00 Add:
$12.00 Add:
Has spent decades under a car and looks like it. Works fine; save money by buying rusty!
$5.00 Add:
$0.50 Add:
To suit all Valiant models except those with Sure-Grip Limited Slip Diffs
$22.00 Add:
This kit includes the ball and trunnion boot and the clamps required to fit it. Note: you may need a larger type if your running gear has been...
$50.00 Add:
Includes Bearing, Lock Collar and Rear Axle Seal. One set per wheel.
$86.00 Add:
$22.00 Add:
To suit all RV1 - Early VC
$15.00 Add:
To suit all models up to early VG
$74.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
Top quality Nolathane brand lowering block kit including U-bolts, extended nuts, washers, and extruded (not the cheaper cast type) blocks. Hey, they...
$125.00 Add:
$2.00 Add:
Includes flat washer
$2.50 Add:
Suits all models with 34mm dia front leaf spring bushes. Price is for 4 Bushes, enough for 1 car
$24.00 Add:
Suits all models with 34mm dia front leaf spring bushes. Price is for a pair; enough to do 1 car
$38.00 Add:
$68.00 Add:
Quality product. Sold as a set of 4. RV1 - VH models require 2 sets per car as they are used for upper and lower shackle bushes. VK - CM models only...
$45.00 Add:
Quality product. Sold as a set of 4. RV1 - VH models require 2 sets per car as they are used for upper and lower shackle bushes. VK - CM models only...
$20.00 Add:
These are the little plastic spacers that go between the individual spring leafs. Dealer book says to suit CM but may suit other models.
$12.00 Add:
Quality US-made product. Sold as a pair.
$155.00 Add:
Quality SuperPro polyurethane product. 4 bushes are supplied; enough to do 1 car
$45.00 Add:
Set includes enough to do one rear shock; 4x Washers and 2x Nuts
$19.00 Add:
$11.95 Add:
Copper-faced gasket, old stock, brand unknown
$11.00 Add:
Standard generic model
$15.00 Add:
Heavier grade than the original. Old stock.
$20.00 Add:
New but looks old as it has been bouncing around the shed for a while
$3.00 Add:
$46.00 Add:
Suits all models from RV1 - VG
$22.00 Add: