Product Image
Item Name
Price
Suits all models except RV1.
$24.00 Add:
If your Upper Ball Joint is fine but the rubber boot has perished, fit a new rubber boot and save around $20 per side. Suits all models except RV1.
$5.75 Add:
5-3/4" (146mm) diameter to suit: RV1 SV1 VF VIP VG VIP Chrysler by Chrysler CL CM High Beam Single Filament Single Beam
$22.00 Add:
5-3/4" (146mm) diameter to suit: RV1 SV1 VF VIP VG VIP Chrysler by Chrysler CL CM High/Low Sealed Beam
$22.00 Add:
To suit all 9" drum brakes. Kit includes springs and clips to suit one pair of drum brakes
$36.00 Add:
Copper-faced gasket, old stock, brand unknown
$11.00 Add:
This is to suit the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models...
$24.50 Add:
This is to suit the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models...
$10.00 Add:
This is the small bolt type which was used for all models from RV1 to VK and some CL models. Other CL and CM models, and any earlier models which...
$44.00 Add:
$50.00 Add:
Suits all models, excluding those fitted with solid disc brakes. Wasp brand
$49.00 Add:
Suits all models, excluding those fitted with solid disc brakes
$43.00 Add:
An affordable alternative to buying new lower ball joints if the only problem with your existing ones is perishing rubber. Suits all models,...
$7.70 Add:
2 per car required for RV1-SV1, 3 required for VC-VG Also fits VH - CM
$7.00 Add:
6 per car. Suits all models.
$4.50 Add:
This is the part that fits into the slot in the door to screw the Armrest to. Sold individually.
$6.50 Add:
Suits both 3 and 4 Speed Gearboxes. Made from rubber, not nolathane.
$43.00 Add:
$20.00 Add:
Suits all models. Quality product made by an automotive OEM
$8.00 Add:
Standard single filament bulb as used in many factory or aftermarket boot or underbonnet lamp assemblies
$1.00 Add:
Includes key, barrel, clip, and the lever that fits into the latching mechanism. Different length levers are included to suit all models
$32.00 Add:
Suitable for use on all models without modification except RV1/SV1. RV1/SV1 owners will need to replace the plug-type connector on the harness with a...
$16.50 Add:
Polished by hand in the USA and individually bagged to prevent scratching. Includes nyloc nut
$4.50 Add:
2-1/8", brass. Suits all 6 cylinder models
$5.00 Add:
$9.00 Add:
$22.00 Add:
$22.00 Add:
2 required for joint between Z-Tube and Pedal, 1 required between Z-Tube and Clutch Fork Adjuster
$5.00 Add:
Suits all models
$8.00 Add:
Set of 4 Clutch Pivot Bushes
$12.00 Add:
$13.50 Add:
Restoration-correct part to suit all Manual gearbox models
$17.00 Add:
$17.00 Add:
Set of 2 MDI Clutch Torque Tube Linkage Dust Seals
$10.00 Add:
To suit Tail Light / Brake Light and Park Light / Indicator Applications
$1.00 Add:
Heavier grade than the original. Old stock.
$20.00 Add:
Standard generic model
$15.00 Add:
New but looks old as it has been bouncing around the shed for a while
$3.00 Add:
55.6mm Fits all models
$10.00 Add:
Lower Shock Absorber Bush as fitted to base of front shock absorber. An affordable alternative to replacing one of your front shocks if the only...
$13.80 Add:
Genuine Mackay, Australian made. Includes inner tubes.
$80.00 Add:
$4.00 Add:
Suits all models
$2.20 Add:
Suits RV1 - CM Slant or Hemi with original Carter Fuel Pump. Quality Australian product. Will not fit the following: Modern sealed Fuel Pump Slant...
$109.00 Add:
Suits all models. If you are missing a Ground Strap and enough money to buy a new one, buy this crusty old one instead and clean it up
$2.00 Add:
Suits all models. If your Fuel Gauge is stuck on empty, the problem could be a poor ground through the Ground Strap.
$15.00 Add:
Suits all models. If your Fuel Gauge is stuck on empty, the problem could be a poor ground through the Ground Strap. This is the stainless steel...
$22.00 Add:
To suit only models with fuel sender pickups that have been enlarged to 3/8"
$25.00 Add:
To suit all models with standard 5/16" sender tube
$33.00 Add:
Suits all models
$9.00 Add:
Correct part for models with J-Bolt. Models which do not use this type of J-bolt may still use this if: the hole in the chassis rail in which the...
$22.00 Add:
$0.50 Add:
Exact reproduction of factory fitted item for AP5 - VK, suitable for all models from RV1 - CM
$28.00 Add:
For use with Ballast Resistor
$58.00 Add:
For use with Ballast Resistor only. Made in Japan
$39.00 Add:
If your indicators are staying on constantly, here is your solution. Two-pin Flasher Can to suit all models.
$14.00 Add:
If your indicators are staying on constantly, here is your solution. Two-pin Flasher Can to suit all models.
$20.00 Add:
If your indicators are staying on constantly, here is your solution. Two-pin Flasher Can to suit all models. This is the larger, more elaborate type...
$20.00 Add:
A hard-to-find part. If you turn your original steering wheel upside-down you will notice a steel ring encircling the steering shaft spline socket....
$7.00 Add:
Standard bulb as used in all dashboard bayonet applications. Note VF - CM dashboards also include wedge type bulbs
$1.00 Add:
$10.50 Add:
$1.00 Add:
Nobody likes to have their nuts seized. Here is the solution to the bang noise you just heard when you tried to tighten your panel nuts up
$1.75 Add:
These are the brackets used to mount the Front Sway Bar to the K-Frame
$25.00 Add:
These are the bushes to suit the aftermarket brackets used to mount an 18mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 20mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 22mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 23mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 23mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 25mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 27mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
These are the bushes to suit the aftermarket brackets used to mount a 30mm diameter Front Sway Bar to the K-Frame
$17.00 Add:
Quality kit with braided sheathing
$110.00 Add:
Quality kit with braided sheathing
$110.00 Add:
Suits all Slant and Hemi engines
$4.50 Add:
These original salvaged conical washers are to suit Slant and V8 engines.
$5.00 Add:
Unavailable as a factory-correct reproduction, these original salvaged washers feature the concave shape. Suitable for both Slant and Hemi
$5.00 Add:
This will fit all Torqueflite transmissions from VF to CM. It can be used to replace the earlier one pin type, which is no longer available, with...
$55.00 Add:
Standard bulb as used in all number plate light assemblies
$1.00 Add:
Suits all models
$16.50 Add:
Suits TorqueFlite 904
$18.50 Add:
$11.00 Add:
$28.90 Add:
Standard Bulb used to light the Radio Dial and several other interior applications
$1.00 Add:
Top quality hose, made in Australia and individually tested to 3000psi. Hoses are made to your order: please e-mail us after placing an order if you...
$55.00 Add:
Suits TorqueFlite 904, Borg Warner 3 Speed Manual, Borg Warner 35 Automatic
$32.00 Add:
Quality SuperPro polyurethane product. 4 bushes are supplied; enough to do 1 car
$45.00 Add:
Set includes enough to do one rear shock; 4x Washers and 2x Nuts
$19.00 Add:
Quality US-made product. Sold as a pair.
$155.00 Add:
Suits all models with 34mm dia front leaf spring bushes. Price is for 4 Bushes, enough for 1 car
$24.00 Add:
Suits all models with 34mm dia front leaf spring bushes. Price is for a pair; enough to do 1 car
$38.00 Add:
Quality product. Sold as a set of 4. RV1 - VH models require 2 sets per car as they are used for upper and lower shackle bushes. VK - CM models only...
$20.00 Add:
Quality product. Sold as a set of 4. RV1 - VH models require 2 sets per car as they are used for upper and lower shackle bushes. VK - CM models only...
$45.00 Add:
To suit Slant 6, Hemi and Small Block engines running camshafts with lift over 0.500". Exceeds E49 and E55 factory specifications. Sold individually...
$15.50 Add:
To suit Slant 6, Hemi and Small Block. Sold individually so 6 cylinder owners can order 12 and V8 owners can order 16
$13.00 Add:
BP5ES
$5.60 Add:
BCP5ES
$5.60 Add:
Quality Australian-made sintered bronze product. Suits all manual transmissions.
$11.00 Add:
Suits manual Steering Box
$35.00 Add:
Suits manual Steering Box
$15.00 Add: